- Notes, cautions, and warnings
- Introduction
- Preinstallation setup
- Installing
iDRAC Service Module
- Initial installation of iDRAC Service Module through iDRAC for Windows
- Initial installation of iSM through iDRAC Express
- Initial installation of iDRAC Service Module via iDRAC for Linux
- Installing iDRAC Service Module on Microsoft Windows operating systems
- Installing iDRAC Service Module on supported Linux operating systems
- Installing the iDRAC Service Module on VMware ESXi
- Installing iDRAC Service Module when the System Configuration Lock Down Mode is enabled
- Configuring the iDRAC Service Module
- iDRAC Service
Module monitoring features
- Operating system information
- Lifecycle Controller log replication into operating system
- Automatic System Recovery
- Windows Management Instrumentation Providers
- Prepare to remove NVMe PCIe SSD device
- Remote iDRAC hard reset
- iDRAC access via Host OS
- Accessing iDRAC Via GUI, WS-man, Redfish, Remote RACADM
- In-band support for iDRAC SNMP alerts
- Enable WSMAN Remotely
- Auto-updating iDRAC Service Module
- FullPowerCycle
- SupportAssist on the Box
- Enabling the In-band SNMP Get feature—Linux
- Enabling the In-band SNMP Get feature—Windows
- iDRAC GUI Launcher
- Single sign-on (SSO) to iDRAC GUI from Host OS administrators desktop
- IPv6 communication between iSM and iDRAC over OS-BMC Passthru
- Enhanced security between iSM and iDRAC communication using TLS protocol
- Frequently asked questions
- Linux and Ubuntu installer packages
Dell EMC iDRAC Service Module 3.4 User’s Guide
Configuring the iDRAC Service Module from RACADM
The iDRAC Service Module can be accessed and configured through RACADM CLI commands. To know the status of the features that are provided by the iDRAC Service Module, use racadm get idrac.servicemodule command. This command lists the features of the iDRAC Service Module and their status. The features are:
- OSInfo
- LCLReplication
- WMI Information
- Auto System Recovery Action
- iDRAC access via Host OS
- iDRACHardReset
- HostSNMPAlert
- HostSNMPGet
- iDRAC SSO Launcher
To set or configure the features, use racadm set idrac.servicemodule. <feature name> <enabled or disabled> .
- NOTE: The name of the feature or the attribute that are listed starting from an # symbol cannot be modified.
To use the iDRAC Service Module from RACADM, see the objects in the Service Module group in the RACADM Command Line Reference Guide for iDRAC8, iDRAC9, and CMC available at dell.com/support.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\